The Blog Post

Scroll through our blog post to learn more about industrial plants and gases used across various industries

Acetylene plant Process Acetylene plants are manufactured with complete in-house know-how to produce acetylene gas. Every part has been carefully designed and …

Acetylene forms an important part of many crucial processes in industries. Although the current uses of acetylene are few, the scope is not limited. In-depth research is being conducted in this regard to ensure utilization of this resource in the most beneficial manner possible. Acetylene is an important natural gas that is put to various uses

Our Acetylene Generator is a “Continuous Flow” type. When the carbide contents of the hopper are exhausted, (the other hopper automatically goes into operation, carrying the load) the empty hopper can be refilled during the time the gas in the generator is being used. In this way continuous service is maintained conveniently and safely. No shutdown operations at recharging period means that you save both labour and time. The Generator may be started or stopped as and when required.

The combination of oxygen and acetylene to cut metals has been in use since approximately 1906. Over the years, acetylene has earned a recognition as one of the safest, yet strongest welding gas. But, there is a rising misconception that propane is a better welding gas than acetylene. This post shares differences between these gases and discusses the benefits offered by acetylene gas in detail.

Carbide lime is a high quality hydrated lime slurry produced as a by-product of the generation of acetylene gas It is produced as a 10% solids slurry and is stored in tanks, where the excess water is decanted to increase the solids content to the 30-40% range for distribution in 5000 gallon tank trucks.

Many methods to stop flashbacks have been devised. Broadly the Interruption Methods can classify the Flashback Arrestors into two types : "Active" methods require maintenance of certain parameters, such as liquid level or gas velocity. "Passive" methods require only routine inspection and typically have no moving parts or instrument requirements.

reasons that may cause a flash back. Hot refractory causes a flash back  If the refractory lining a burner or furnace is …

The flashback arrestor should be placed at the closest point to the flame, if due to unavoidable circumstances the Arrestor can not be places close to the cutting nozzle or the flame then it should be placed of the main pipe line, and also on the fuel gas bank, vessel, cylinder.